I cut the 2 layer top to size using my DEWALT TrackSaw. Bigger would be better but I can’t afford more space in my shop so this will work fine for most applications.
![delta unisaw reviews delta unisaw reviews](https://i.ytimg.com/vi/-AxJuZvmeRA/maxresdefault.jpg)
I set the depth just wide enough to allow me to rip an 8 foot long piece of plywood and have the center of gravity still on the table. The length was set to match the end of the Unisaw. This table is approximately 42 inches deep and 71 inches long. I glued and screwed the two layers together prior to cutting it the the final size. The top for the table is built from two layers of 3/4 inch thick Birch plywood. Obviously that would be a very serious situation and one to avoid at all costs. I do this to avoid any chance of wood on the table saw hitting the leading edge of the outfeed table and causing a binding situation. I keep my outfeed table approximately 1/16 of an inch lower than the table saw cast iron top. These allow me to level the top with respect to the table saw. The supports not only help keep the frame square but they also gave me a location to screw the top to the frame from below.Įach of the legs has a heavy-duty adjustable leg attached to it. Lastly you can see I installed corner supports again using pocket screws. I positioned the middle shelf at a height so that my DEWALT TSTAK organizers would fit just below it. The middle shelf consists of one layer of 3/4″ plywood screwed down to the lower rail supports. These are screwed to the inside of all the legs. After building all the legs I cut 3-1/2″ wide support rails for the top and middle shelf. In the photo above you can see how the legs are pocket screwed together (Kreg Jig). For the center two legs I used single pieces of plywood so they would not interrupt the middle shelf.
Delta unisaw reviews install#
I calculated the height of the table to match the table saw and then subtracted 1 inch (so I could install adjustable leg supports for fine tuning the table height). I used my Kreg Jig to screw them together in an L-shape. First I built legs using 3-1/2″ wide pieces of plywood. I have lots of it hanging around the shop from a recent cabinet project so it was a great way to use it up. For this table I wanted to have plenty of easy access storage for tools, jigs and materials.Ī majority of the frame was built with scrap 3/4″ cabinet grade Birch plywood. Outfeed tables can take up lots of valuable floor space.
![delta unisaw reviews delta unisaw reviews](https://m.media-amazon.com/images/I/61rTD0UjnfL._AC_SL1200_.jpg)
![delta unisaw reviews delta unisaw reviews](https://i3.ytimg.com/vi/vh7jWno6Kfs/hqdefault.jpg)
In this article I’d like to share a design that I created for an outfeed table that matches my Delta Unisaw. In addition, they often serve as an assembly table and storage cabinet. They making cutting large sheet stock easier, safer, and more accurate. Outfeed tables are one of the most useful companions of a table saw. Custom Outfeed Table Built To Match Unisaw